*:::::::the official what did you do to you mkiv today thread::::::::*

[shdwmkiv]

replaced control arm bushings

[Shaffer199]

Went an drove bought 100 miles to pick these up for $200.00!!

They need a little TLC! Haha

[scirockalot8v]

removed my junk brembo rotors.


one wheel done. just need to paint the center.

[daryl2.slo]

Drove it to the gym, looked at my odometer 101430
Waiting on my ball joints to come in tomorrow so I can replace mine and as well the control arm!
Then finally run my brock's

[_Brenon_]

Cleaned the inside of that bish.

I'm not cleaning the outside again until this damn pollen calms down.

[Doctor Meat Does Housecalls]

Passenger side inner tie rod.

Fun stuff.

[CHRGRS_VW]

Changed my oil.

Sent from my GT-I9000 using Tapatalk

[JayDD007]

Hit 111,111.1 miles!

[daryl2.slo]

i missed the ups guy and didnt get my ball joints today! But i went ahead and took the passenger ball joint to get a jump start for tomorrow when i get them, and honestly its not bad!
and my axle outer boot is leaking

[SoIAteAPancakeToday]

Ordered some Bilstein rear shocks to replace my blown raceland ones. Should help me get some more lift too

[perickomx]

bought it!!

[Jake2k]

Well it was last week but had it painted! Or rather made Geico paint it

[Doctor Meat Does Housecalls]

Got an alignment today. Felt some grinding on the way home. Figured it was swaybar/axle sexy time because I spun my coil down to match the passenger side before the alignment.

Got home and went to take my wheel off, lug nuts were loose as ****.

-_________________-

[Shaffer199]

Replaced my driver side window after shutting my door yesterday an it shattering...

[Burth]

Axles!

[LC6X]

Got a text message that she is complete, just waiting for a break in the weather so I can go get her back

[daryl2.slo]

just did my passenger ball joint, as you can see it was at its end, still need to do driver side. Was feeling lazy and going to do it tomorrow!


waiting to do a control arm and lower it then get alignment then put these bad boys go on!



then of course save for a cw mkv gti

[mk2vr6akavteckiller]

I did plugs wires and a k&n filter....im really liking the mk4 world....

[mzeffex]

Tried my hand at body work. Not too bad.

[hcuunt]

Also did this when i replaced my passenger wheel well, new stubby antenna, and some under-body plastic piece replacement.

[Miller7204]

Wheels went on finally!

[Big_Tom]

bought it!!

i bought another car this week too

[Clean PG]

Also did this when i replaced my passenger wheel well, new stubby antenna, and some under-body plastic piece replacement.

if you ever want to get rid of those sideskirts, let me know

today i'm going to give mine a bath and oil change, a bit overdue....

[riceeater00]

Changed my ignition switch... Finally I don't have to worry if my car will start or not

[pentaxshooter]

if you ever want to get rid of those sideskirts, let me know

today i'm going to give mine a bath and oil change, a bit overdue....

That's my picture/car And, no you can never have them You def need some new skirts, though!

[senor ice]

washed it. i know needs moar low. but im like it the way it is.

[Jake_182]

I did this:


After hitting the elusive suargo cactus... about $1000 in damage.

[Diller]

Used it to jump start a dead fox body mustang at work, and made plans to get a new turbo back exhaust.

[Schümey]

Deceided to take the Golf to work because of this

[Burth]

bought it!!

Welcome sir!

[daryl2.slo]

Washed and waxed my indigo blue gti and forgot how much I loved it and can't wait to put the wheels on!



But I see a cw mkv gti in my future

[DibbleDUB]

replaced my half shafts, mounted tires to my new wheels, washed her and took pictures

[BrettNZ]

Made ramps so it doesnt ground everytime it goes in and out of the garage

[mKsTurbo]

took a nice ride .. weahter was perfect for the turbo

[mk3_vdub]

let's see, I adjusted the shifter cables, checked all the fluids, cut out that annoying piece at the top of the fender well that holds the fender liner, replaced the bolts for my cage, and tried to devise a strategy to move my exhaust up because the rear beam is resting on it preventing it from getting any lower. oh and I also took out my siebel horns because they are blown, and put my stock ones back in.