Bump
#1
ATP 12v VR6 Exhaust Manifold
Barely used, sitting idle for most of it's life.
Flat Charcoal Thermocoating
Perfect Condition $275.00
From ATP's copy
"ATP cast iron VR6 manifold designed for T3, T3/T4 or T04 turbo applications. Will work for both MK3 and MK4 VR6 cars. Hi-temp cast iron 1/4" walls prevent cracking under severe heat. Precisely drilled for head studs and threaded (8mm x 1.25") for both T3 and T04 inlet bolt patterns for versatility and ease of installation. *Cast with external wastegate flange, but can be blocked off with blockoff flange for integral wastegate setups."
Last edited by IntakeManifold; 01-29-2012 at 02:41 AM.
NETL : Whipped Antiques
MFTUNE : A cuddy indeed.
#34
So, has this already been ported for a T3? Did you have it installed and run on your car?
What's your zip code please?
#35
It was not ported. It will fit a T3 or T4 , it comes this way. Do some research.
It has been used for a short time, then thermocoated. It has been unused since the coating was applied.
NETL : Whipped Antiques
MFTUNE : A cuddy indeed.