Too late to get in on this? damn
Hey guys here is an update: We are VERY close in being able to start production we were able to fix the fitment issue that we encountered before in the last test fit of the bumper but this time when we hung the bumper we noticed (and it is in just one section) the indention line that goes through the whole bumper, looks like something might have got in the mold and raised the line just a bit as pictured in the 3rd picture below, not a huge deal but we have to fix it in the mold which is a little tricky because that line has to be consistent and perfect before we can start sending them out obviously because once you paint these bumpers you will defiantly see it so we dont want to start production until it is resolved. We are working on fixing it now and will run another part early next week and give you guys pictures, as you can see that seems to be the only remaining issue. Here is a couple pics not sure why they are so saturated I believe it was a filter on my friends cell phone camera but I took a good shot of the problem in picture # 3 with my camera so you can clearly see the issue.
Last edited by sales@optikwerks; 04-26-2012 at 03:44 AM.
Blue 03' VW GTI 1.8t ~ Uni Stage 2, 3'' Eurojet Downpipe, AWE Tuning Cat Back, AWE Boost Gauge, Eurojet TIP, ECS N75 Race Valve, Halo Headlights, 15 Tint On Front, 5 Tint On Back+Windshield, Fk Streeline Coilovers, ECS Cold Air Intake, 42DD Shifter Bushings, Stage 1 Dogmount Inserts
My Build/Progress Thread