Hey guys, I am thinking about doing a AWD set up on the coupe. The engine that is going in the car is MKIII 3.0L VR6T that is fully built!
Here is the car...
I am looking to buy a whole R32 shell that also includes:
-linkage & shifter
-4 ABS Sensors
-ABS Control Module
-ESP Control Module
-The two Combination Sensors (Accelerometers)
-Steering Angle Sensor
-Undamaged rear floor pan (salvaged title on shell)
-Rear end w/ suspension, diff, controller, brake lines, etc.
-Exhaust w/ cats
-Gas Tank w/ evap
-Fuel pump and sending unit
I have no problem doing all of the sheet metal work on the rear. What I am concerned about is what electrical work am I going to need to make the haldex work???
Any idea's would help!!!!