vinyl wraping

[AE2058]

Anyone good at it, I could use some help. I'll be buying some more very soon to redo all three parts.


My first attempt. Any pointer would be helpful.





Little rough around the edge's

[chrisarmy2003]

lol really doesnt look that bad, a few months ago i gave it a shot and tried to do the mirrors and rear wing on my mk3........yea i took it off. your actually right around the corner from me if you live in bruchmulbach, i live in haupstuhl.

[Notabora2]

Where are you buying the vinyl? The reason I ask is because I bought some cheap stuff in the past and it did not stick well. Now I am using Vinyl from a company called Metrorestying.com. They have just about everything yo need and it shrinks well with a heat gun. I have my interior trim on my Audi covered in Carbon black, the outside pillars in Carbon black, wagon hatch in flat silver. I will be doing more of the Audi this weekend. I will do the hood, and maybe the mirrors. Not sure yet.

[Heidelberg2az]

^^ that looks pretty dope. Good job of putting it on

[88Jetta350]

Thanks for that link, man. Been looking for a place that carried 3M vinyl, in the pattern I wanted, for a while now.

Feel like wrapping a few parts for me when it gets here?

[Notabora2]

Its not extremely difficult. There are hundreds of videos on the U-tube. You need a few items.

exacto knife
alcohol/claybar
masking tape
heat gun/hair dryer
squeege....with a felt-tip

and patients!

Use low heat....below 70c

on large parts, start with applying half and when that is done, do the rest. If you want to see, I will be doing some parts on my car tomorrow and then again next Saturday.