WTB: 15" meshies

[capri2mn]

Newbie here.

Looking for a set of 15x7 (or 7.5 or 8) mesh wheels with a PCD of 4x108. Would prefer a bit of dish to them and backspace needs to be less than 4.5" so I don't have to run spacers.

All brands/models considered except for Enkei 92s, will even entertain 14", though I prefer 15".

Really like Compomotive CX300s, SSR mesh, Enkei EK98s, etc.

What have you got? Pics/price required!

Thanks,

Dan
Elk River, MN 55330

[capri2mn]

bump

[capri2mn]

anybody?

[capri2mn]

125 views and NOBODY has a set of 14" or 15" mesh wheels to sell?

Somebody's hoarding!

[capri2mn]

Still looking!

[Nash20thAE]

I have a set of mesh Enkei 16x7's I have 5 of them and aluminum hub rings to mate the wheels to a 57.1 centerbore. Price is $600 and is firm. Four of them are perfect and one has a small chip in the lip. One of the good wheels is spray bombed a bronze color. All come with center-caps. Pics are here.
Bronze wheel:

16x7 et23:

Mounted on my CQ:


Let me know. I'm located in NJ 08361.

[capri2mn]

Beautiful wheels, Nash20thAE, but I'm gonna pass. Not sure my project, a 1976 Capri II, will look right with 16" wheels and rubber bands for tires.

Still looking!

[mopman93]

I have what you're looking for but they are 4x100. Considered redrilling the hubs?

[wide opn]

not sure if this interests you, but a have 3 Enkei EK98's 15x7 +19 offset. I just bought them and was planning on cleaning and refinishing them to resell. All 3 are dirty and have some paint peeling on center sections (gold) but are in good shape otherwise and will clean up very nicely! If you have any interest, let me know and we can discuss price.

[capri2mn]

Sorry folks, been away from my computer for awhile.

Mopman93 - you've peaked my curiousity. What have you got? Re-drilling would add to my overall cost, but...

wide opn - one concern I have would be how difficult it might be to find a fourth wheel. I could find one the next day or be on the hunt for years!

Dan

[wide opn]

Sorry folks, been away from my computer for awhile.

Mopman93 - you've peaked my curiousity. What have you got? Re-drilling would add to my overall cost, but...

wide opn - one concern I have would be how difficult it might be to find a fourth wheel. I could find one the next day or be on the hunt for years!

Dan

Thats a fair concern Dan! I had the exact same concern myself. I would sell them for a good price, leaving you far ahead of the game if and when you do find a 4th. If you want to discuss further, just let me know. thanks

[capri2mn]

Ok everyone,

After much looking, I have narrowed my choices to just 2:

Enkei Apache V (first choice) or Enkei Apache IV (second choice)

At this point, I realize that I may not be able to be so choosy on size, so let me know what you have. I still would prefer 4x108 with a minimum 4" backspace, but am open to the options of re-drilling, using spacers/adapters, and even rim size. I'm not even sure what sizes these models were available in!

Thanks,

Dan

[capri2mn]

I'm almost ready to give up! Doesn't seem to be anything out there.