So here's the deal. My tun signals dont work. At all. No lights on the dash for them or any of that. However the Hazard light still currently work. I have replaced every single fuse in the block under the dash. Changed the Relay. and installed a new Signal switch from German Auto Parts. The plug-in for the Turn Signal stalk doesnt look corroded. I think It could be a ground issue but then the Hazard lights should not work either in that situation. Checking the bulbs is pointless. Being that all light up when using the flashers. I'm really hoping somebody can help here. I'm about to rip the fuse block out. However again. Relay for the Flasher and the Turns are the same thing. I'd think if one works both should work. Thanks for the Help in advance!
I'll leave this post up incase somebody else has this problem and needs it. I found my issue. The fuse slot was worn out. Fuse wouldnt fit tightly so i had a bad connection and no working turn signals. I used a small 90 degree pick and pryed the tabs out a little for a tighter contact. Will be replacing the block soon though to avoid further problems.