Up.
#1
Will NOT part this out.
Located in RI/Eastern CT
Will consider shipping.
I purchased this kit to install into my Rabbit 'Caddy' Pickup that has a 1.6l Diesel engine- life has gotten in the way and I won't be having time to do WVO. The tank was custom made to go under the bed in the area where the spare tire is supposed to go. The kit is entirely brand new and unused and should easily go into a Pre-MKV Volkswagen TDI- the tank measures 26"LX21.5"Wx7"D with 1.5" mounting tabs on the edge of the tank- these tabs could be easily cut off if you're looking to put this in the trunk of your Jetta or Golf or Passat TDI.
The benefits of the Frybrid over the Greasecar kit includes that there is NO copper in the tank and that the fittings are brass and that the coolant fittings are outside of the tank- there is over 30 square feet of heat exchanging area. The fuel lines are aluminum and there is a a purge warning cycle. The micro controller automatically switches over vegetable oil once the fuel comes up to temperature without buying the extra grease car computer.
This kit includes:
Heated Filter
Controller
Heat exchanger
2x 3 port solenoid valve
2x hose ends
tube thread sealant
20 small clamps
7 3/4" clamps
9 5/8" clamps
5/4" and 3/4" T
3/4 to 5/8 adapter
Coolant Temp Switch
Red/Green/Yellow Indicator lights
Tottle Switch
Buzzer
Push Button
10 Ring Connectors
15 Spade Connectors
6 butt connectors
1 large ring connector
1 inline fuse and holder
20 Tec Screws
10 1 1/4" P clamps
10' Fuel line
10' Aluminum Line
50' Coolant line
The tank- missing fuel level sender
I'm basically taking a huge loss selling this kit without use, but such is life. $1500.
![]()
Last edited by khuygie88; 03-25-2012 at 02:56 PM.
#11
Started my corrado TDI conversion today, could use some project funds
#12
Does this come with instructions or just what is shown? Also you say this will work on a 1.9 is that correct? What is the bottom dollar you will settle for?
olharleyman@hotmail.com