white ligts are racing dash lights. They have like 20 leds inside.
red lights use 194
Footwell light instructions: http://audi-diy.blogspot.com/2007/10...installed.html
Trunk lights is basically this to remove panels, but on both sides: http://forums.fourtitude.com/showthread.php?2741663
1. Torx screw
2. torx screw
3. pull up
4. pull where the arrow is going
5. run cable
6. shows u where to run cable
7. cut 8 vents off like in picture( I think i did it wrong on this
one, because the driver side is one vent above the lower vent not 2
vents higher than bottom. Double check your car first. And double
check before you cut, but its up to you to see where you want to put
the light. You can only cut once I suggest you cut 6 vents off first
then test fit and cut and test and cut.)
then put everything back in in reverse order
06 door pin in the 32 pin.
1 should be power
2 should be ground.
2 should be brown. If its brown take it out the female pin from the connector and connect it to the male pin on the harness. Use the supplied heat shrink to wrap those 2 connectors together. Connect the female end to the #2 connector housing. The harness has 3 pins, 2 females and 1 male. The one with the 2 pins together(male and female) is the ground wire.
same as all doors for 2006
VCDS need to activate door exit/warning light
Goto chassis tab on top
goto 42,52 for front
62,72 for rear
you will need to go coding. then add 64 to the total for door exit/warning lights installed.
pin 18 for power
19 for ground
FOR 2006 Please use pin 1 power and 2 ground for front doors
FOR 2007+ Use 18 power, 19 ground
Ground wire will be the wire that has the split
These pics are 2006 model year. 2007+ please find the pin 18 and pin 19 and do as above.
BROWN wire always ground.
1: remove the brown wire, use pin or small flat head
2:Connect the male end from the cable loom to it the brown wire
3:Use the supplied heat shrink tube to cover the open connection
4:Ground cable goes to 2 and power goes to 1. (2007+ use 18 and 19)
LOL, i don't have time either I had ordered the red warning lights from this company last week and it still hasn't shipped. So I waiting to get them so I don't have to take the doors apart twice.
By the way, where are you going to be at SOWO? Is your car going to be at a booth or are you just parking with the rest of the population?
Last edited by neu318; 05-15-2012 at 10:16 AM.
Cool. Thanks I'll check it out. I'm going to SOWO with almost 30 people so I'll try to find time and see if others want to join