Parting out six speed stage 3 S4 in PA (alcantara, k04's, fueling)

[jtp]

do you have the gauge cluster? if so any pixel problems? and how many miles on it?

[_muppet_]

I do have the cluster, pulled it out yesterday. Mileage is 145,362 and it does have some pixel issues. The center display works fine when the car is cold, but as it warms up it fades out.

[_muppet_]

01e needing rebuild is sold, panzer plate is sold, side skirts and lower door mouldings are sold. Nice to meet you and your girlfriend Brandon, enjoy the parts.

[SinisterS4]

PM sent on the piggies, k04's, inlets.

[s4chow]

Hwve u ever change those get sensors".."I'm lookin for aem is those on ur engine any good

[s4chow]

Hwve u ever change those egt sensor".."I'm lookin for some is those on ur engine any good

[_muppet_]

I have never changed them, I assume they are the originals from the car, but I am not sure if the previous owner changed them or not. I have one spare on the shelf that I bought used, but never needed it, they are all code free.

[UpstateBrah]

Still have the driver side mirror? If so, how much shipped to 12047?

[90golfproject]

Picked up parts this weekend, great guy and seller. Thanks again!

[_muppet_]

Thanks, drivers mirror was sold to the guy below you, sorry.

Took some more pictures, and still pulling more parts off.

Samco hoses, missing one upper intercooler hose, I was just using the stock one pictured and will include it with the set. I also don't think the y pipe hoses are actually samcos, they were sold to me as samcos but are not stamped samco, and look a little lighter in color. $65 shipped





Fuel pump and fuel rail, the pump was bought from tulin when my stock one went out, but I don't recall the mileage on it. It is in good working order though.



A set of misfire free coil packs that I bought on audizine a little while back, if you want I'll also throw in the original set from the car, that I think two of had misfires, but there are still some good ones I just replaced them all at once.



Got the fender off, has some paint flaking near the bottom around the wheel area, I'll come down on it a bit. pick it up and I'll take $40



Abs block and wiper motor/ arms



B pillar covers, drivers side has a small spot of paint missing as pictured from the weather stripping on the door making contact.



Steering rack, one tie rod end was just replaced last winter, still have the other in the package that can go with the rack.



Good drive shaft



stock s4 front sway bar, don't know if anyone needs these or not, I don't know if there is any difference between the a4 bars and the s4 bars or not, have the rear also, if anyone is interested.



Door strikers, also have all latches removed and all door wiring harness's if anyone is interested.



Have all the door frames and glass out, didn't get shots of the passenger side, but can get some of anyone wants them. The passenger front window regulator was replaced just last winter, the rear passenger was replaced maybe two years ago, both drivers side are the originals as far as I know, the drivers door window regulator had a cracked clip that I put a piece of copper wire through and has been working that way for a couple years now, but I thought I should mention it.





Intake manifold/ throttle body



a set of side markers



what'seft of the center console parts, console itself has a couple broken tabs, but I'm not sure what they are for as I didn't see any bolts behind them. The cup holder is broken, and the hvac control pixles act up a bit (minor) sometimes. Sometimes a couple of the bars that show fan speed don't light up, and sometimes when it's cold a random pixel or two will light up. Also have rear ash tray, but didn't get it in the picture for some reason.









The engine is as stripped as I am going to take it unless someone has a request for something, but the heads are staying bolted to the block, as this is still a complete long block and ready to run. The timing belt, water pump, and thermostat were done at 98,xxx miles by Rstyle performance in loveland OH, I have receipts for this that I just found today, they were the ones who installed the motor into the car.









Also for the guy that asked, I got the piece of the bumper cut out, I am trying to find a box it will fit into, sorry that's taking me so long.

[pooted203]

Pm sent

[_muppet_]

replied

[jeffha4]

PM Sent

[dirteeboy808]

pm sent

[b5in]

EGT sensors available, if so how much shipped to Chicago, IL 60607?

[_muppet_]

EGTs are available $45 shipped each, or $80 shipped for a pair.

[_muppet_]

I'd like to get some of these bigger items out of the garage. price drops:

seats, door panels, aluminum beltline trim - $600
engine as most recently pictured - $750
six speed transmission - $800
coilovers - $250
fender - $25
door frames (as pictured with glass, window regulator and motor) - $30 each
trunk lid - $45

These prices are picked up as these are items I'd rather not ship.

If anyone needs passenger side door shells, these are ok, the back one has a couple scratches on it that might polish out, the front looks pretty good. The drivers side rear has bad clear coat peel, and the drivers front is chipped up bad from being opened into the fender that slid back. If anyone wants these, come get them asap, because the car is close to being scrapped.

[S4_Girl]

I need a gas tank...how much to 24740? Also how much for the front and rear seats?

[b5in]

EGTs are available $45 shipped each, or $80 shipped for a pair.

I'll take the black one, PM me your paypal address

[_muppet_]

Pm sent

As for the gas tank, I'm not really sure about the regulations as far as shipping a gas tank goes, but I know if it is ok, it will be pricey as it is very large. I'll send you a pm.

[_muppet_]

up

[_muppet_]

bump

[Jordan80]

Thanks for the clutch kit sent you another PM

[.Mad Hatter.]

armrest lid and ebrake handle?

[jettadrvr94]

Sent PM regarding shifter rod

[_muppet_]

armrest lid is sold, still have e-brake handle.

[.Mad Hatter.]

bummer. No worries though, I think I can source the handle locally.

[charliet]

Front axles ?? Saw a post further up the thread, but no response.

[_muppet_]

Sorry, I have at least two sets sitting around. I have a set of stock axles and a set of jhm solids. I think the drivers side jhm axle has a hole in the outer boot if I remember right. I would have to look at them, I know I bought two sets of jhm axles because the first set was loud, and I thought they were bad, the second set was also loud, so I went back to a set of oem axles. I will check them over for boot condition and play and get some pictures for you.

[R32dreamer17]

[_muppet_]

I would also be interested in trades for camera gear. nikon stuff, would swap the interior or the motor for a d90 body, or d300 body, or lenses. All prices are negotiable as I would really like to get some space in the garage, way too much stuff sitting around right now.

[_muppet_]

bump

[Zdriver]

Sent pm

[mmfn]

pm sent

[_muppet_]

updated the first post with some prices and available items, if you think of something odd that you don't see listed feel free to ask about it.