most recent pics
most recent pics
Last edited by bvgoosedd; 04-17-2012 at 12:27 PM.
engine rebuild, not sure how bad the damage is. no hole through block or anything noticeable
Wow bad hit and you just painted the wheels was the motor built
^^^Big Turbo build lots of pics^^^
Best shop for repair and custom workin ma
Everyone keeps asking
here's a little video too! http://youtu.be/Q25cD6GYH_k?hd=1
~135K on body and Tranny and clutch kit including flywheel has less then ~1500 and Big Turbo kit Less then ~20K
KINETIC MOTORSPORT AUDI TT 225Q 1.8T TURBO HARDWARE KIT
Product ID : KNAUDI-TT225Q-HW
- Garrett GT3076R (+$795.00USD)
- Race Pipe - Cat Delete
- Kinetic FMIC Kit (+$795.00USD)
- 630cc Siemens (+$199.96USD)
- 630cc Unitronic Mafless (+$700.00USD)
- Kinetic Fuel Pump Kit (+$225.00USD)
- .63 A/R T3
Brute 144mm Connecting Rod Set 20mm
ACL Rod Bearings
Clutch Masters FX400 with single mass flywheel $1300 (http://clutchmasters.com/index.php?m...v_products.tpl)
Cross Drilled Rotors in 312mm with Hawk Pads, Front and Rear (HPS)
Blueflame - 225/180 Quattro Stainless Performance Exhaust
Tial Q 50mm BOV $250
Aem Tru Boost $270
Devils own Water and Meth $200
factory car comes narrowband so i also did a wideband convertion
These are things car has in it. definatly missing so things. pls feel free to text me if you have any questions.
Last edited by bvgoosedd; 04-10-2012 at 02:35 PM.
So your gonna sell car as a whole then
Sent from my Motorola Electrify using Tapatalk 2
infinity front and sides,votex rear,st coilovers,eurodyne tapp 1000cc tuned,hks ssq bov, pte 5857 pagparts turbo kit with 38mm tial wastegate. spec stage 3, custom intake, bbm fuel rail, billy boat 3in exhaust,ecs bleeder block,mbc,fmic,bfi mounts,cm flywheel,front mount interccoler, aeb head cat 3652 cams, scat rods je pistons super tech valves and springs.
Yea i don't want to part it out too much work plus everyone keeps asking for little things. i actually took the oil pan down and the damage isn't that bad so i may fix it but if some1 offers what i want for it as a whole i'll let it go.
just so ppl know the block is good from what i can tell. i took the oil pan out and block still spins. put a 19mm 12point on the crankshaft and still spins but bearing are gone so car is perfect for a 2.0 stroker like this one
i it doesn't sell that is what i plan on doing to the car.