Mirror turn signal removal

[MasterJetti08]

Gonna tint these and I just want to make sure I have the correct info on how to remove them. Alls I need to do is pop the actual mirror out with something plastic (so as not to chip it) and then from there I should be able to pop out the turn signals correct?

[DüB NüB]

Um, Personally I don't know if that's all that is needed but it wouldn't hurt to check the DIY sticky if you haven't already

[MANU01]

Need to remove the mirror motor also to get to the 4 or 5 torx screws, no more than 10 minutes a side.

[driftme]

Gonna tint these and I just want to make sure I have the correct info on how to remove them. Alls I need to do is pop the actual mirror out with something plastic (so as not to chip it) and then from there I should be able to pop out the turn signals correct?

glad you posted. if you did that, you'd likely break your whole mirror assembly - there are a bunch of torx screws holding everything together.

http://www.ecstuning.com/stage/edoc/...rrormarker.pdf

read that, its a good guide.

[MasterJetti08]

Yea seriously. Thanks a lot guys. Thisll be a big help. And no thanks as far as buying the smoked signals. Ill just tint them myself. That's what I did with my side markers and they turned out great.