24V VR6 downpipe wont fit

[twin2626]

I removed the old downpipe. Only 1 broken stud and a disintegrated exhaust clamp.
I cut the old pipe at the Y section to be able to remove it easier. But when I went to install the new pipe (Just an OEM pipe), I can't get it up in between the subframe and the heat shields.
It basically won't go up in through the hole. I just have the car jacked up as I don't have access to a hoist.

Anyone else run into this issue?

[spitfire481]

i had to lower the sub frame to install my techtonics downpipes if that helps you any

[madonion]

The other way I think you could try is by removing the manifolds, but there's a risk of braking a stud. I don't know if there would be enough room to fit the downpipe under the hood.

[twin2626]

It worked. I lowered the subframe a little and jammed the thing in there. What a PITA. I didn't want to risk breaking any bolts on the manifolds.

Thanks Everyone.