Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Results 1 to 3 of 3

    Thread: Mirror Turn Signal Issues

    1. Member
      Join Date
      Apr 9th, 2005
      Location
      Graham, Wa
      Posts
      178
      Vehicles
      1997 Jetta GT, 2010 JSW TDi
      04-29-2012 06:06 PM #1
      My mirror turn signal suddenly started strobing instead of blinking. It has been working fine, but I do have the following code and noticed the same code a few weeks ago when I had last done a scan:

      Address 42: Door Elect, Driver (J386) Labels: 3C0-959-70X-GEN4.clb
      Part No SW: 3C0 959 701 B HW: 3C0 959 793
      Component: TUER-SG FT 002 0307
      Revision: 13101005 Serial number: 0000596162
      Coding: 0004F5
      Shop #: WSC 01383 790 50316
      ASAM Dataset: EV_DCU42BroseDriveSide A03004
      ROD: EV_DCU42BroseDriveSide_VW36.rod
      VCID: 277329615EF6351

      Slave Driver:
      Subsystem 1 - Part No SW: 1K0 959 703 AH HW: 1K0 959 795 T Labels: 3C0-959-70X-GEN4.CLB
      Component: J388__TSG-HL 006 1401
      Serial number: 00000004738489
      Coding: 0004D0

      1 Fault Found:
      67589 - Turn Signal in Exterior Mirror
      B11FD 01 [009] - Electrical Failure
      Confirmed - Tested Since Memory Clear
      Freeze Frame:
      Fault Status: 00000001
      Fault Priority: 2
      Fault Frequency: 254
      Reset counter: 137
      Mileage: 43054 km
      Date: 2022.14.05
      Time: 05:31:55

      It sounds like the LED board may be failing. All 3 still light up, and everyone once in a while, they blink fine, but 99% of the time now they just strobe 2-3 times per blink. Anyone else have any experience with this?

    2. Junior Member
      Join Date
      Apr 1st, 2010
      Posts
      33
      Vehicles
      2010 Jetta TDI
      06-02-2012 02:04 PM #2
      I've had a similar issue. For me, I need to have the turn signal stalk replaced. If your cruise control starts acting up than that's prob the issue. GL.

    3. 06-04-2012 03:15 AM #3
      Before you replace why not to do a Outpuut Test to eliminate good parts and focus on the faulty.
      Activate needle illumination in ALL MICRONAS cluster since 2004 up to 2010. Activate STAGING for all NEC cluster since 2008 even if not availabe in adaptation chanel.

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •