FS New 1.8 BT Parts

[gtimitch]

Divorce induced Project sell off.
The 1.8 motor has never been fired and all parts were bought new (except the block and crankshaft). I began collecting these parts in 2008. The car is a 2002 1.8T GTI with a short throw B&M shifter.
Here is my pars list – the motor is now assembled and in the car but the wiring is incomplete.
• Block Bored to 82mm.
• Honed and line bore checked, and block was decked per Wisco specs and cleaned.
• New Scat forged rods (balanced) with ARP bolts.
• Wisco 8.5:1 forged pistons and rings (file fit).
• Crankshaft polished and checked.
• New main and rod bearings.
• New Race Ware main studs and nuts.
• New Oil Pump
• New water Pump and Timing belt kit (all new tensioners and belt)
• New AEB big Port cylinder head with Supertech aftermarket exhaust valves and Cat springs, Stock lifters, non VVT cam tensioner.
• Cat Cams 268 (3652) grind hydraulic cams.
• Aftermarket adjustable cam gear.
• New cam sensor
• Unitronic 830 BT File (set up through Force Fed Engineering)
• New head bolts.
• New Garrett 3582 with anti-surge housing (compressor is 56 trim .70 A/R) (the turbine is 84 trim .63 with an anti-surge housing)
• New coolant lines and oil lines with all new hardware to bolt the turbo on.
• New Precision 600hp FMIC with 2 ½” tubing on the hot side and cold side..
• New Pag Parts Exhaust manifold.
• 38mm Teil waste gate (piped to atmosphere).
• 50mm Teil BOV.
• Mass Air Flow - Delete - 4” intake tubing and a cone filter.
• 3” down pipe to a 3” Test pipe and muffler to complete the exhaust.
• Walboro 255 fuel pump in addition to the factory in-tank pump.
• Aeromotive adjustable fuel pressure bypass regulator with 034 motorsports silicone gauge.
• Ross fuel rail.
• 80mm DBW Throttle Body
• 830cc fuel injectors.
• SEM big Port intake manifold.
• New bolt down coils, new plugs, and wiring harness.
• Greedy Stage 2 Electronic Boost Controller.
• New radiator
• All new coolant lines and connectors
• New catch can with 12AN screw connections and Nylon braided hose.
• New oil cooler with 034 motorsports forged ¾” to 12AN adapter.
• New Coolant sensor and thermostat.
• New dip stick.
• New Raxles axles with nuts and bolts for installation (guaranteed for life).
• Differential fitted with a Wavetrack posi unit.
• New South bend Stage5 clutch with new hardware for instillation and throw-out bearing.
• New Brake slotted rotors and brake pads.
* (1) Street Density Line Engine mount
* (1) Street Density Line Transmission mount
* (1) Track Density Line dogbone mount
* (2) Density Line strut mounts
* (2) OEM Bearings for the strut mounts

Anyone interested please send a message but please only serious inquiries...The more you buy the better your deal. Mitch...

http://s302.photobucket.com/albums/n...%20Comparison/

http://s302.photobucket.com/albums/n...0VW%20October/
Mitch.....

[jagt21VR6]

Wow what a build, sorry to see ya have to get rid of it, interested in a few parts...bump

[Three3Se7en]

PM'd good looking stuff here

[gtimitch]

PM'd good looking stuff here

I have received the messages, please be patient with me and I will try to get answers as quick as possible. I have a whole lot going on right now and I'm fitting this sale into a tight schedule...Please note, all these parts are new (never used), they are bolted on and ready to run but the motor has never been fired up. I will supply some pricing as soon as possible. Please check the links at the bottom of my parts list a few more details.
Thanks folks..

[gtimitch]

Crap, I have this setup with the pump:
http://forums.vwvortex.com/showthrea...anks-are-HERE!
And this:
http://www.vadmobile.com/products.htm#STS-457
and the cams I have are custom from QED----I don't think I can even come close to getting half of my money back on this build - I may just try to figure a way to starve my way through it..lol..BUT if there is a hungry racer out there - my ears are open.
I have solid shifter mounts and --man -- so much more... I don't think I can part this up and feel right about it. It is custom built to work together and - your not going to like this- but - I want to sell it together to a very serious 600whp buyer..... or, maybe, just try and figure a way to keep it.. Its going to take a true poker-face and some greenbacks to get this sweet little drive-train - but it won cost you 2/3rds what it cost me...I'm rambling now sorry..

[jagt21VR6]

And you shouldn't! I wish I could afford it and I'd offer 10 grand if I had it! Worth that and much more I'm sure..good luck with everything keep this if you can put way to much effort and work into it, sorry if I'm enabling....

[gtimitch]

Thanks Jesse, mighty kind of you sir. I'm trying to make the impossible happen and its pretty tough right now. I was married 31 years -can you believe that? Now I'm going to have to start over again and its a little *gulp* scary. I was a faithful husband so I have a lot to learn....Probably too much info for you sir, sorry. I will keep in touch with you. I plan to go through my receipts this weekend and post them to see how it goes. I really don't want to sell - but if I can generate the cash I need, I will. Your words of encouragement are very much appreciated.

[jagt21VR6]

I can't even imagine I'm young and a dumb 26 year old living with my gf! Anyways, you just do your best to keep it install it and next time I come down to Hilton head well go for a hell of a drive! Id love to bring our 2002 bimmer but shes not really made for those long trips, will def bring the gli hopefully with either a gt28rs or 50 trim by then though!

[MattPlante]

How much for radiator shipped to 73018?

[clean'nblackmk4]

Is that lifetime warrantee from Raxles transferable?

[zerosimple]

PM sent

[dasautony]

How much for Brake rotors and brake pads?

[fast02mk4]

I just picked up an 03 gti that is about to become my BT project. I'm interested in all of it if the price is right.

[ManikGTI]

Inter cooler rods and fuel pump prices shipped to 97030

[gtimitch]

Its all gona sell -- I hate it, but my recent problems as well as some medical crap is gona take my project and some....

[gtimitch]

Sorry folks - things have been absolutely crazy ... I will answer your questions as best I can - please check you messages for the specifics... I had some major heart stuff done and the delays have spilled over onto everything.

[gtimitch]

The radiator will sell for 100 clams – it’s the heavy duty unit made for the mid-west. You will have to check for the shipping. My Zip is 30907…And that’s my price me friend… (I will throw the fans in as well/ with the shipping weight)…. and for an additional 25 bucks I will sell the new hoses – top and bottom – with the new OEM clamps.. Can’t get that kind of deal from a pawn shop my friend….

[gtimitch]

The brake rotors are slotted with Hawk pads... I will sell them for 140.00 and you pay the shipping. They are still in the box. my zip is 30907. That is my price my friend..

[gtimitch]

My package deal cost me in the upwards of 11k (for the motor and trans) Its all new stuff... If I could get my hands on 7500 to settle my estate - I would let everything go - even the car (without the sound system) The car has a short throw B&M shifter with the solid shift mounts ---and well -- you get the picture... it breaks my heart - but its all for sale and I will take the loss - I even have new coils (bolt down) -- wiring harness ---lots of other stuff - but the car has been setting up since 2008...thats when I began to spend the big money on my little dream.......now I need to work on a new life -- before I can concern myself with a dream..TMI sorry folks......That is what I have to have and its a major loss for me (on just the motor) than what I have invested - then of coarse you could add the rest of the car...lol

That's not true folks - it was well over that figure, I just don't want to come to grips with the actual cost right now --- cause it isn't bragging rights -- its a little humbling.....

[fast02mk4]

Pm sent

[fast02mk4]

Please call me (865) 705-2834. I'm extremely serious and can very much appreciate the time you have spent on this beast! Hope to talk to you soon.

[nesisg]

pm'ed

[bad_news]

I'd buy it all if I had the time to install it. Car is apart but motor is together just not fired?

Who put the motor & head together?


GLWS!

[skitclip]

do you still have the timing belt kit? how much you want for it?

[gtimitch]

Friends,
This is the list of parts and my asking prices. These are also the prices that will be going on Craig's list and Ebay tomorrow. Please bare in mind, everything is unused except the Block (which was machined and prepped), the Crank and the 5speed Trans which now has a new bearing kit and seals along with the new Wavetrac. I still have a lot of new unlisted parts including a new gauge pod with boost, new oil cooler, catch can, all new hoses, new coolant reservoir, a never used VCOM kit with the dash-mount (came with a new phone which has never been activated) .. a lot of stuff....Just let me know -- The motor is together and was built by me. The front end has not been completed (nose) and the wiring is incomplete - but the entire motor assembly is together (without the FMIC or piping for it. The radiator is still in the box.
Oops - forgot the brake rotors, pads and bearings. I will add them later.


To calculate shipping, my zip code is : 30907

[FaelinGL]

PM Sent.

Mike

[fast02mk4]

PM sent

[V-DUBchic]

i didnt see the oil catch can on the list. Has it already sold?

[blackcat1]

I'll take the raxles. Would you sell the adjustable cam gear seperately? PM me your PayPal

Sent from my Kangadore 64▦

[Three3Se7en]

Pm'd

[Scullies]

pm'd x 2

[gtimitch]

Thanks folks for the all the interest expressed in the post for the parts I posted - I just had someone come by and purchased the entire car......I think he will be well pleased with his purchase and we will likely see some of his updates soon - of the finished car.

Thanks again --- the car is sold.........and He was a VWvortexer.....

[gtimitch]

Thanks folks for the all the interest expressed in the post for the parts I posted - I just had someone come by and purchased the entire car......I think he will be well pleased with his purchase and we will likely see some of his updates soon - of the finished car.

Thanks again --- the car is sold.........and He was a VWvortexer.....

Fast02mk4 bought the whole package ---- he drove about 6 hours to find me and liked what he came for... I very fine man and --- he had cash. If you would like to contact him about extra parts - feel free -- but I do not know what he might want to sell. He seemed very happy to me

[johnsomj]

pm'd