FS: Lots of VR6 parts!

[mor3deadmau5]

I have an OBD2 intake manifold setup. Comes with upper and lower manifold, injectors, fuel rail, valve cover, and throttle body. 50$



I also have an other upper manifold, valve cover, and an OBD1 throttle body.
Upper mani is 20$ valve cover and throttle body are both 10$



Water pump pulley. 10$



Stock down pipe with ceramic coated exhaust manifolds and a relatively new oxygen sensor (no plug) 50$



Two stock systems with oxygen sensors (one with cut plug, one uncut). Both have cat convertors, one has a small mid muffler too. 40$ a piece



Manual ECU. 30$



Charcoal canister i think? 10$



Good coil pack without an ICM. 10$



Three chain side plates, one with complete top. 20$ for the complete. 10$ for the incomplete one with a bearing, 5$ for the one without.



Two exhaust shields. 5$ a piece

[mor3deadmau5]

Manual starter. 40$



Good clutch, but its got surface rust on the machined sides. Needs to be cleaned.
25$

[mor3deadmau5]

throw me some offers!

[President Lincoln]

I am always interested in a complete obd2 setup. That ecu u have does it end in 258 or 259? Can't read it on my smart phone...

But what I really need is a vr6 speedometer cable.. any chance u have that?

[OG16VGLI]

I am always interested in a complete obd2 setup. That ecu u have does it end in 258 or 259? Can't read it on my smart phone...

But what I really need is a vr6 speedometer cable.. any chance u have that?

258 AT at the end of it.

[Davespeed]

Dibs on water pump pulley. IM me your PayPal and shipping.

[President Lincoln]

258 AT at the end of it.

Aka obd1 - Thx.

[mor3deadmau5]

Let me know about the other stuff

[mor3deadmau5]

Make offers! this stuff is taking up too much room

[mor3deadmau5]

[mor3deadmau5]

offers!! i need this junk gone!!!!

[mor3deadmau5]

taking most of this stuff to the scrap yard tomorrow morning if it isnt gone!

[mor3deadmau5]

Still have most of this stuff