MSnE V1 2.2 going lean at elevation

[frechem]

Here is my feedback looking at the logs:

You have no MAP range to speak of, which is common on ITBs. Make your lower kpa bin ~45-50 and spread the load bins out a ton more over that range. All of your low kpa should be handled by overrun fuel cut so you'll have to set that up. I would also change your afr targets a bit and get rid of anything leaner than 14.7:1 for now, the old AFR table with a tweaked MAP range would work better.

OK great, thanks for the advice!

Would it be possible to have you tweak my tables and MSQ to what you you were thinking?

You have a lot more knowledge and experience in this area than I do.

[need_a_VR6]

Perhaps, email me at kandpperformance@gmail.com