the measurements are 12mm when touching the needle and seat, and 26mm when hanging. you measure with the gasket in place
Anyone know the correct PLASTIC float bowl height for Weber 45 DCOE carb or where to get the info ?
I think my floats are flooding my carbs cause when i try to start it up if i touch the gas at all it kills all chances & when i do get it running i see a lot of fuel in my V-stacks almost dripping out. + can't get to idle
Last edited by MicroCADDY; 06-01-2012 at 09:27 PM.
I take it the 12mm is when you adjust when holding the top vertical
OK so while Adam & I last month was trying to tune my carbs ( unsuccessfully ) we notice the 1 carb really spitting out fuel in the V-stacks. Figured it would be the floats need adjusting. So today i was doing so & noticed something missing yet again.
GOOD one with all parts
BAD one missing parts
Needle Valve or lack of. ( part # 79503.200 )
This might just be the reason for to much fuel LMFAO
BTW if anyone has this part sitting around LET ME KNOW i'll buy it