Parting my turbo car, I have a complete 6spd conversion for mk3/corrado. Trans has about 2k on it from a fresh rebuild. Peloquin diff installed with arp bolts. shift forks bolted, not riveted.. trans is clean and painted silver. Good for 500whp easy. I'll be pulling it out of the car shortly and sending to my trans guy, for an inspection and 100% clean bill of health. No noises, trans shifted great, never had a problem with it. Shift weight/pin was modified to work with the 12v thermostat housing w/o hitting. I also have a european polo shift box which bolts right in place of the 02a shifter, no cutting. Also avail are my DSS 2.9 conversion axles with 2k on them, sdezego 02m mounts which are very beefy, and a clutch / PP /flywheel setup. I guarantee all my parts to be in perfect condition, I don't sell junk.
Trans (comes w/ new release bearing/slave) & clutch line: $2300obo
Polo shift box: $225
Dss axles: $675
Single mass eurospec 22lb flywheel (rare) $300
Clutchnet 2x pressure plate and full face copper disk: $400
Mounts (front and rear): $275
Sorry i dont have a great pic of the axles, heres what i have:
I am not here to tell you how to perform a transmission swap, If you don't know what vehicle/motor this bolts up to, and are too numb to figure it out, please don't waste my time. I will respond to SERIOUS BUYERS ONLY.