New pics up scroll down price drop. $3500w rims 2500 without Bought this car back in sept of last year. Have put a good amount of time money and work into it so far all the heavy and hard stuff is done. It's basically a project car that I don't have time to finish. Bought from a great guy I met here. . Here's the rundown.
219k on body and interior
Shaved side markers
New shaved hatch
Top 2- years old
Interior is all there an original to the car
Hid single round hella lights
Crystal clear and red tails
Pioneer cd with rear USB input
Studio 5-1/4 up front on ppi amp
Two kicker tens in back with kicker mono amp
Two Polk 4" components for rear (uninstalled)
Wiring needs to be cleaned up.
2.0 16v swap digi2 with tt high rev chip
Bbm fuel rail and fpr
Stock block n internals approx 127k
Rebuilt head with vr6 springs approx 17k
Bbm fuel rail with vr6 injectors
Vr6 oil pump
Stock 16v exhaust mani with high flow TT cat back
New timing belt and water pump/thermostat less then 500 miles
New poly control arm bushings less the 500 miles
All wheel bearings
New caliper up front and all new pads
New drum and shoes
Stainless braided lines
Bn 0 miles racelands
New strut mounts up front
Scirocco K bar and neuspeed upper front strut bar
Bn still not mounted klutch 15x8.5 rims
Bn tires new ball joint(still needs one)
All new oil seals and gaskets will come with car as well as a bn axle assembly
Front brakes are from a scirocco
Rear brake drums from a mk3
Trans was rebuilt with head
Weighted short shift kit(needs adjusting or rebuild have a bn rebuild kit for it) still shifts fine but if your not used to it first can be tricky. Easy repair.
New(2 years old) manual steering rack with poly bushings. Steering column was put in a bit off so steering wheel is off center. Annoying but that's it turns drives and tracks great. Will probably need an alignment after I install coils and new rims. Maybe not we will see how close I can get it.
Have poly motor mounts uninstalled
The new axle which I bought but it turned out to be wheel bearing so it's nib.
Valve cover gasket
Oil pan gasket oem not rubber crappy one
Dizzy oil gasket(need to install leaks a bit not bad but it's annoying topping off and having a dirty engine.
Also has 14" wheels with 20-30 mil adapters for storing car on or whatever tires are good rims are bbs but beat to ****. Extra sway bar and all original side mouldings will come with car. Will need a windshield has crack in it.
All in all it's a great running car needs to be finished off to be what I wanted it to be but it's fast and reliable. All the major work has been done (swap,trans,suspension wheel bearings brake swaps etc)
I need a car for my gf to drive automatic. So trades are good accepting any reasonable offers too.
Also taking Volvo Honda Acura or any other German cars nothing American.
Would take a Toyota pickup as well
Automatic is ok as well.
This is a photo shaved markers and the 14" wheels that will come as spares
Last edited by vwcrackerjack; 08-15-2012 at 06:50 PM.
Still have wheels. $800 cash missing one center cap. Cap is $30 shipped from wheel studio. Rims and tires have less then 100 miles on em cost $780 tires were 300 and getting em stretched on the right way was another $160. Not taking anything less then $800 or a hard cover for my Honda ridge line.