1990 Corrado VR6 Turbo Syncro

WVWDB4501LK025414

1995 OBD1 VR6 Motor

Racecraft Fabrication (NJ) Custom 6 point roll bar, fully welded

Megasquirt MS3/MS3X ECU

Kinetic T3/T4 Turbo Kit

Custom Syncro 2.5” downpipe

2.5” Stainless side exit exhaust with Flowmaster Hushpower muffler

ARP head studs

Mocal thermostatic oil cooler plate

Mishimoto oil cooler heat exchanger

Motor has all new plastic cooling parts

Motor has new timing chains

Air to Water Intercooler with giant front heat exchanger

500hp capable clutch

02C Transmission fully rebuilt with all brand new syncros and bearings

Transfer Case rebuilt with new bearings and seals

TDI (0.75) 5th gear

Peloquin differential in front transmission

New radiator

New Single 12” slim fan

New H&R monotube coilovers

Custom welded in Camber plates in front

All new wheel bearings

Custom heater core with defrost for windshield

15 Gallon Fuel Cell

Stainless firewall for fuel cell

Battery relocated to trunk in plastic battery box

Passat glass moonroof

Stock Corrado G60 blue dot front seats

European Corrado 3 point lap belts

European Corrado manual window regulators

16” Enkei wheels, freshly refinished in gray powdercoat

New 205/40-16 Falken Azenis tires

New Dual piston Audi Girling G60 front calipers

New MK4 aluminum rear calipers with stainless lines

New Hawk brake pads

New DriveShaftShop Stage Level 3 Axles (good for 500hp)





Car is tuned for 1 bar (15psi) of boost on 93 Octane gas and makes 350whp. Dyno proven and tuned by Rick Gifford of Bald Turbo Freak Racing.

The car runs and drives great. I recently drove it 10 hours round trip on vacation without issue. It gets 25mpg on the highway @ 80mph.



The paint is good on the car, it isn’t perfect, I would say it’s a 8 out of 10. The roll cage does have some chips in it as seen in the photos from driving the car. The car has about 15K on it since it was painted. It was previously ran with a G60 Syncro setup, the VR6 and all the above parts were installed this spring.

The windshield has a crack in it about 10" long. I have a good one that can be included in the sale.

I'm only selling because I have way too many cars, and need to thin the herd. The car is fast, and smooth.

Car will need to be picked up in Rochester, NY
I can help with shipping if necessary.

$12,000/BO

NO TRADES!!!