audi fault help

[twomeyconor]

16-Steering wheel -- Status: Malfunction 0010
44-Steering Assist -- Status: Malfunction 0010
46-Central Conv. -- Status: Malfunction 0010

-------------------------------------------------------------------------------

Address 16: Steering wheel Labels: 1K0-953-549-MY8.lbl
Part No SW: 1K0 953 549 AH HW: 1K0 953 549 AH
Component: J0527 036 0070
Coding: 0000002
Shop #: WSC 06314 000 00000
VCID: 78F5C1400BC86A9

1 Fault Found:
00883 - Ignition Switch (D) Terminal S
012 - Electrical Fault in Circuit


-------------------------------------------------------------------------------
Address 44: Steering Assist Labels: 1Kx-909-14x-44.clb
Part No: 1K2 909 144 M
Component: EPS_ZFLS Kl.078 H08 1901
Shop #: WSC 02069 000 90108
VCID: 36690F78415C5C9

1 Fault Found:
00446 - Function Limitation due to Under-Voltage
002 - Lower Limit Exceeded - Intermittent
Freeze Frame:
Mileage: 71850 km
Temperature: 37.0°C
Voltage: 7.60 V
Voltage: 7.40 V


-------------------------------------------------------------------------------
Address 46: Central Conv. Labels: 8P0-959-433.lbl
Part No: 8P0 959 433 J
Component: KSG H11 0080
Coding: 1880202002186D298505489AC637
Shop #: WSC 06314 000 00000
VCID: 438F66AC028EF91

Part No: 1K0 951 605 C
Component: LIN BACKUP HORN H03 1301

Part No: 1K0 907 719 C
Component: Neigungssensor 005 0003

Part No: 8P0 951 177
Component: Innenraumueberw.H04 0020

1 Fault Found:
00849 - S-contact at Ignition/Starter Switch (D)
008 - Implausible Signal

-------------------------------------------------------------------------------

End ---------------------------------------------------------------------


looking for a bit of help with this fault i got on a 2008 audi a3 1.9 tdi, is it a hard problem to fix?

[Peter@Ross-Tech.com]

Have a look at the following links from our wiki pages:

http://wiki.ross-tech.com/wiki/index.php/00883

http://wiki.ross-tech.com/wiki/index.php/00446

http://wiki.ross-tech.com/wiki/index.php/00849

[Jack@European Parts]

In addition to Wiki link checks.

Verify Grounds and all connection points as per WD.

Ignition switch must be inspected for meltdown and the module itself could also be faulty.