bump... all pms replied
#1
Found something else I want to get, and need to free up some money, so my project has to go. will partout or sell it all together.
shell sold
mkIII party seats. Good condition, fronts have 5 point harness build into seat bracket sold
obdI aba motor with 135k. Has 9:1 compression hg spacer, arp headstuds, new water pump/t stat, new timing belt/tensioner. Has ac and power steering delete. $400
cluster, ecu, full car harness, fuse block from same car as motor $200
5spd o2o from same car with fresh redline fluid. has 90mm flanges installed for mkI swap, but have 100mm as well. $250
custom made exhaust mani/dp to fit perfectly in a mkI. Will work on any aba mkI-III. t3 flange$700
t3/t4 turbo 57trim from kinetic kit. 15k on turbo. Has a little shaft play but still works great $250
short runner intake mani w/ obdI throttle body. Made to fit stock fuel railsold
Precision Intercooler from mkIII kit. 3.5" thick 2.5" inlet/outlet. Has small knick but holds pressure fine$75
Tapped oil pan $75
4 Bosch #42 injectors $125
3" vw oem maf housing sold
BFI mkI stage 2 motor/trans mounts with brackets. can have 4 or 5 speed trans bracket brand new$125
Also have random boost pipes, hoses, and clamps
Last edited by tard cart; 10-23-2012 at 09:19 PM.
formally pow3r hour
#12
Someone come pick this shell up Im gettin a new car on sat and need this gone. Make an offer, just need it gone asap.
formally pow3r hour
#14
Nice turbo mani seems well made. How
Did u spool with that mani I'm considering it
d.i dubinvasion.co
#15
what are the chances you have the original aba manifold. also how much for motor?
#18
nope, everything is good. I think I have 2 of them actually
formally pow3r hour
#19
Another question i forgot to ask is, will the stock intake mani still fit? Seems like the turbo would keep it from fitting
d.i dubinvasion.co
#23
How Complete is the interior?
all good with the title?
If only I invested my money into something more practical then a VW....