scratching my head

[dstorti]

i have a 2002 gls tiptronic

i also have a 2001 gls 5 speed

I swapped the motor,trans,ECU,cluster and key fob and I have immo light on

I can't figure it out


When I did the swap I just did motor and trans and I still had an immo light
Used vag tacho pulled the skc number tryed repeatedly to program with vcds with the skc and no luck

[dstorti]

i also have purchased vag com for this project

[AmIdYfReAk]

Could you clarify?

the 2001 Engine and automatic are in the 2002 shell?

[dstorti]

no sorry the 2001 engine and rans which is a 5speed are in the 02 shell which was a tippy

[AmIdYfReAk]

You'll get a few transmission based codes, but i will run and drive down the street without an issue.

[MrAkalin]

You'll get a few transmission based codes, but i will run and drive down the street without an issue.

[18T_BT]

Isn't the snout on the crank different from auto to manual?

[dstorti]

it was a complete swap motor and trans were installed as one unit its just that it was a tippy ecmi wanted to use so i dont get immo bs

[dstorti]

okay im stumped on how to wire the car so it will start all mechanics are done except for wiring to start the car and im really scratching my head now

[dstorti]

donor car is 2001 gls 1.8t 5 speed manual

project is 2002 gls 1.8t tiptronic 5 speed

i have installed the whole 2001 motor,trans,clutch flywheel as one unit 105k
i have the ecu also installed from the 2001

i took the tcm out and removed the tcm harness out of the engine bay to the rain tray

i also installed the engine harness from the 2001 to the ecu but left the stock harness that runs the rest of the stuff

i am just unsure where i need to hook the white clutch switch to and the blue cruise control switch im assuming is not a priority

[dstorti]

i have searched and searched and have just not found the same situation where using all the stuff from my donor car to make it a sweet install i would have just gutted the car harness from under the dash if i knew i would be this stumped on something that looks so easy on the surface lol

[dstorti]

okay i have the car cranking but not starting like there is no fuel i dunno

[dstorti]

Edit on the first post for new circumstances lol boy oh boy I hate this

[youlostme21]

Dont you need the cluster to match the pcm?
I would try that first.

[dstorti]

i did swap the cluster i needed to do the lock cylinder also everything is good now