Machining 40et to a 45et. is it possible? Miro 111

[keepitlow]

I want to run a set of staggered Miro 111's on my MK6 golf and in order to properly pull it off I need the rear wheels (18x9.5) that only come with a 40et offset to be machined down to a 45et.

Anyone know off a macine shop or company that can pull this off if I send them 2 wheels? All that needs to be done I guess is 5mm shaved off. I know it seems like a lot of work for some Miro's, but staggered concaved wheels look sick.

[4ceFed4]

5mm is a lot of meat, machine shops are going to need to take a look at the pads while the wheel is off the car to see if there is enough material there to starting shaving it off.

[DoctorDoctor]

From my understanding, 5mm is the absolute max that a shop would take off (assuming they feel comfortable taking on the job in the first place).

Might want to try your regional forum. Who knows, you may get lucky