You guys think i'll be able to run those if i top mount them?
Sup guys! Well, I plan on buying a set of CCW classics but they're reverse mounted, I was wondering if anybody knows if they can be brought back to top mount. The guy I'm buying it from had it custom built to be reverse mounted and if I were to top mount it. Would it add at least 10-15 mm? He says that he had the faces cut like how BBS LM's get reverse mounted. The current reversed mount wheel specs is 18x8(f)et 25, 18x9(r)et 19
Here's a link to the wheels:
Last edited by darrrentruong; 10-05-2012 at 04:52 AM.
I don't see why you couldn't...everything should be the same diameter its just a matter of stacking them up differently.
Last edited by SoSoA3; 10-05-2012 at 10:08 AM.
Without seeing the mounted side of the face... it cannot be confirmed. Some wheels are built differently and since he states that he had these custom cut to fit as a reserve mount... it is possible that you may not be able to do it, or you may be able to send the faces back to ccw to be cut again to mount the typical way ccw's are mounted.
I would assume that the difference in offset would be between 10-15mm.