So your an advanced user which doesn't like to follow directions for the forum.
Apparently not enough time to read.
Put your old stuff back in then.
#1
Hello everybody!
I'm that crazy man who have nothing to do but KESSY retrofitting on my GTI VI
I did wiring and had bought all components.
I tried twice to adopt components on my local vw dealer (with on-line connect) but failed.
An error occurs and nobody has idea how to deal with it
Address 05: Acc/Start Auth. (J518) Labels: 5K0-959-434.clb
Part No SW: 5K0 959 434 B HW: 5K0 959 434 A
Component: VWKESSYPQ35GP 085 0902
Revision: 00085000 Serial number: 0138253623
Coding: 030C0C
Shop #: WSC 00135 935 10496
ASAM Dataset: EV_KESSYPQ35G A02014
ROD: EV_KESSYPQ35G_VW36.rod
VCID: 3449CC1F9F497EB8F5D
1 Fault Found:
65826 - No Basic Setting
B2010 00 [009] - Signal Amplitude Too High
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 6
Fault Frequency: 1
Mileage: 0 km
Date: 2000.00.00
Time: 00:00:00
Dealer's VAS told:
Error ERP0630E - no coding information
Does anybody has any idea how to overtake it?
Remarks:
J518 KESSY is used
J764 ELV is used (but looks like it successfully adopted - now my VIN is already inside it)
keys - new, clear, never been coded, but during adaptation keys were not recognized
Probably I have to use special sequence for adaptation? Next problem that the car is silent, no chance to switch on ignition until successful coding. Any adaptation possible only with emergency lights on.
#2
So your an advanced user which doesn't like to follow directions for the forum.
Apparently not enough time to read.
Put your old stuff back in then.
Jack Shapiro E.P.E. VAS>ASE Extern VST-3/1 LAB (TECH INQUIRIES ARE TO BE IN WRITING )
7076062 NYS DMV SAE>NASTF>VW-Audi GEKO Authorized
European Parts Emporium/Performance --- Immobilizer Solutions LLC --------
Postadresse: 1001 State Route 17K Montgomery New York 12549 USA
vwemporium@aol.com -845-457-9808 TEL 9AM-5PM --------TAKE CONTROL OF WHAT YOU OWN!!!!!!
#3
Have you purchase new antennas, keys, door handles and old kessy unit and ELV?? This is very important. I think that with old kessy is important use all old accessories(antennas, door handles). Dashboard is your?? How software version have you in dashboard(kessy support only software 0400 and higher)??
Important before installation kessy:
Coding these units:
BCM(09)
Steering wheel(16)
Gateway(19) - add unit on address: 05 and 2B
Better will be if you do it complete list of all your units in car.
Last edited by hrdinaveliky; 10-06-2012 at 05:52 AM.
#5
And ignore Jack, he has unresolved hostility issues. Most of the forum members will answer a simple question in a civil manner.
#6
hrdinaveliky (great_hero - in translation) is really smart guy who gave me a lot of useful advises