Alright, I swapped out my bulbs yesterday with LEDs.
The process takes about 5 minutes for each side.
1- Angle wrench (see pics) or a similar angled tool
3- Screwdriver with torx bits
4- Size 194 LED bulbs
1- Wrap the curved part of the wrench with the towel.
2- Tilt mirror all the way down, and place the angled wrench behind the mirror and pry out, use a quick nudge, usually two nudges will do it. Do not attempt to do this on the sides of the mirror, left or right...that's where the cracking will occur.
3- Unscrew the 3 torx screws holding the tilt module in place. Have pliers ready to catch the screws. Screws falling into the mirror housing will no longer be a quick job.
4- Tilt module is now out. Pull out the black wire housing (the thick housing with the white sticker around it, that's holding all the wires together) from the plastic clip for better access. I'm pointing to the clip below
5- The blue and green wires connect to the bulb harness that needs to be removed.
6- Pull out the bulb harness with pliers. Be extra careful and do this slowly. My first time, the bulb came lose and fell inside the light housing. I ended up taking apart the entire mirror assembly to remove it.
7- Here is he 194 bulb.
8- Swap it out with your LED bulb and open the door to make sure the bulb lights up before putting it all back together! LEDs have poles, so if it doesn't light up one way, turn the bulb around and put the base in the other way.
Put everything back together and you will now enjoy this quick mod the next time you unlock or open the door.
And here is the bulb I used. Size 194 from eBay. I bought a dozen of them for $4.99