I've had this engine in a few cars, but never ran it for more than a few minutes. It has been sitting in my garage all Plastic Wrapped for a year or two now.. and I'm tired of tripping over it. I have no foreseeable project to put this in.. I'd give someone a KILLER deal on this thing if you came and got it ASAP. Located about an hour outside of Philly and Allentown, PA. in Gilbertsville, PA.
2.0 16v 100miles on motor
Ross forged pistons
bored 20 over
TT stage 3 head
Autotech Sport Cams
powder coated Gloss White
9A 16v Head with Autotech "Sport" Cams
ARP Head Studs
New Headgasket, Valve cover gasket, timing belt, tensioner, etc
Custom TIG welded, shaved, and smoothed Valve cover powder coated mirror red with an ultra gloss clear
Custom TIG Welded, Shaved, and Smoothed Audi 20V 5cyl (one runner removed and shaved) short runner intake manifold with VR6 Throttle Body TIG welded and smoothed into the manifold
Stainless Hardware on manifold and valve cover
This engine was all rebuilt when I received it a number of years in a trade and I had it running in the vehicle I got in trade.. the vehicle I traded for just this engine and some VWMS parts.. so I parted it out. I have since had it in a couple cars, but never got around to finishing each and pulled the engine and wrapped it up in my garage. It needs some edges of holes and such cleaned up from light powder overspray.. but otherwise it's ready to bolt into the car and hook your desired turbo to.
$1200 OBO Pick up only. Just the custom work I have into the valve cover and intake manifold would cost close to this if you had a shop do it...
Here is how it looked before I took it out of the other car and customized it a bit. The car was setup horrible on Digi 1 and never ran more than a few minutes before I deemed the car a lost cause (due to rust and poor bodywork) and pulled it all to clean up, simplify and put into a Mk1.