I just traded in my 2015 GTI SE DSG for a 2018 GTI SE DSG a week ago and was about to do some of the mods like Mirror Dip and Window closing with Key Fob and some of the mods i had done on my 2015 didn't work or couldnt find modules etc because apparently the MK7.5 has just enough new stuff that it some of it doesnt work.
I did a ton of searching but alomost everything I found was for just the Mk7 not 7.5. I'm a novice at most of this so i'm not about to go playing around and break something but was able to find some help on the MKVII Golf R page. so here's what i found:
https://forums.vwvortex.com/showthread.php?8927457-MK7-5-Golf-R-VCDS-Tweaks
I haven't tried any of these yet and some are Golf R specific but if any of you have some that you've worked out i figure this would be a good place to put them all and save others a lot of searching. there are also a couple that i'm looking for if anyone else has some ideas
-Rain Closing that works (I know right?)
-Stop Start Default Off turn on with Button
-Removing the NAR Headlight restrictions to the Dynamic lighting
-Anything else you think is cool.
Originally posted by AWDWagon on the above thread:
"** Note that the coding below works on my new 2018 (built 01/18) vehicle with the updated modules **
DRLs and fog lights as Coming/Leaving Home
09 - Central Electrics
Adaptation – 10
16-Security code 31347
Aussenlicht_Uebergreifend-Coming Home Leuchten -> "Fog light" (default “Low beam”)
Brightness of license plate lights
09 - Central Electrics
Adaptation - 10
16-Security code 31347
(6)-Leuchte25KZL HA59-Dimmwert AB 25
Set to "60" - Default setting is 127
Disable the little red led's on the side of the taillights
09-Central Electrics
16-Security code 31347
10-Adaptations
(1)-Leuchte27NSL RC6-Lasttyp 27 to "not active" (default: "43-allgemeine LED")
Disable Orange LED in Front Headlight
Module 09 - Central Electrics
16-Security code 31347
10-Adaptations
Leuchte26NSL LA72 - Lichtfunktion A 26 - change from “Standlicht allgemein (Schlusslicht: Positionslicht: Begrenzungslicht)” to “nicht aktiv”
Mirror Dip on Reverse
Check this post
Fan Level Display on Auto (Climatronic)
08 Air Conditioning
07 Long Coding
Go to Byte 11
Enable Bit 6
Retain Heated Seat Setting
08 Auto HVAC
Adaptation and change the following:
"retention of the seat heater level driver" to active (default is 10 min.)
Refuel Quantity
Amount of fuel used since the last fill up (refuel quantity)
17 Instruments
Long Coding
Go to Byte 10
Enable bit 4
Windows up/down with remote
09 - Central Electrics
Adaptation - 10
16-Security code 31347
ZV Komfort-Comfort opening-> “active” (default: Not active)
ZV Komfort-Comfort closing-> “active” (default: Not active)
ZV Komfort-Funk Komfort oeffnen-> “active” (default: Not active)
ZV Komfort-Funk Komfort schliessen-> “active” (default: Not active)
ZV Komfort-Menuesteurung Komfortbedienung einstellbar -> “adjustable”
In H/U, Car - Setup - Open and Close - Conv. opening (all windows or drivers window)
Roll windows up/down with hand in handle, thumb on dimple
09 - Central Electrics
Adaptation - 10
16-Security code 31347
Schlusse_Zugang-und Startberechtigung-Kessy Komfort oeffnen-> "active" (default "not active")
Windows Up After Car is Turned Off
09 Central Electrics
Adaptations
16-Security code 31347
ZV Komfort
Freigabenachlauf FH bei Tueroeffnen Abbrechen -> “Not Active” (default: Active)"
Please feel free to add anything that you have personally tested.