I have a 2010 Passat 2.0 tsi with dsg trans, replaced the engine due to dropped valve, and now that everything is back together, when I put the car in any gear, I get this light grinding noise with no movement......almost like gears that aren't meshing together?
I first thought....did the flywheel splines mate properly with the trans input shaft, but I assume the engine and trans wont mate without the two being aligned correctly?
I also had the right stub or axle flange removed to get the engine out....and I did ensure the flange was seated and bolt is back in correctly.
Any ideas what could cause this? NOise goes away in park or neutral.
Thanks!
I first thought....did the flywheel splines mate properly with the trans input shaft, but I assume the engine and trans wont mate without the two being aligned correctly?
I also had the right stub or axle flange removed to get the engine out....and I did ensure the flange was seated and bolt is back in correctly.
Any ideas what could cause this? NOise goes away in park or neutral.
Thanks!